Common failure causes of Wood Round Rod Making Machine and how to eliminate them
In the production process of charcoal rod making machine, the use of rod making machine directly affects the quality of machine-made charcoal, so the safe and efficient use of charcoal rod making machine is the primary condition.
Mechanisms’ common postings and solutions for charcoal machine equipment:
1. The reason why the power indicator of the console is not bright: a. Connect the power supply of the mechanism charcoal machine; b. Replace the fuse; c. The indicator is broken.
The solution to the power indicator of the console is not bright: a. Connect the machine power to the charcoal machine; b. Replace the fuse; c. Replace the indicator bulb.
2. Reasons why the motor of the rod making machine does not start: a. The control button of the rod making machine is damaged; b. One phase is missing; c. The voltage and frequency do not match.
The solution to the motor does not start: a. Replace the estimated control button on duty; b. Connect the power cord; c. Check the voltage and frequency.
3. The reason why the heating temperature rises slowly and does not reach 350 degrees: a. The power supply voltage of the rod making machine is low; b. The resistance heating ring of the rod making machine is damaged; c. The model of the rod making machine is incorrect when the heating ring wire is replaced.
The solution to the heating temperature rising slowly and not reaching 350 degrees: a. Check the voltage of the rod making machine; b. Replace the resistance heating ring of the charcoal machine; c. Replace the rod making machine wire as required.
4. Reasons for dead eyes: a. The screw tip is deformed and bent; b. The screw tip is not smooth.
The solution to the dead eye: a. Correct the coaxiality of the screw tip; b. Polish the screw tip.
5. Reasons for the stick not forming: a. Cooling treatment is enough, remember not to cool down too fast. b. Repair the screw as required.
6. Reasons for failure to produce rods and material return: a. Insufficient temperature; b. Excessive screw pressure.
Wood Round Rod Making Machine
Mechanisms’ common postings and solutions for charcoal machine equipment:
1. The reason why the power indicator of the console is not bright: a. Connect the power supply of the mechanism charcoal machine; b. Replace the fuse; c. The indicator is broken.
The solution to the power indicator of the console is not bright: a. Connect the machine power to the charcoal machine; b. Replace the fuse; c. Replace the indicator bulb.
2. Reasons why the motor of the rod making machine does not start: a. The control button of the rod making machine is damaged; b. One phase is missing; c. The voltage and frequency do not match.
The solution to the motor does not start: a. Replace the estimated control button on duty; b. Connect the power cord; c. Check the voltage and frequency.
3. The reason why the heating temperature rises slowly and does not reach 350 degrees: a. The power supply voltage of the rod making machine is low; b. The resistance heating ring of the rod making machine is damaged; c. The model of the rod making machine is incorrect when the heating ring wire is replaced.
The solution to the heating temperature rising slowly and not reaching 350 degrees: a. Check the voltage of the rod making machine; b. Replace the resistance heating ring of the charcoal machine; c. Replace the rod making machine wire as required.
4. Reasons for dead eyes: a. The screw tip is deformed and bent; b. The screw tip is not smooth.
The solution to the dead eye: a. Correct the coaxiality of the screw tip; b. Polish the screw tip.
5. Reasons for the stick not forming: a. Cooling treatment is enough, remember not to cool down too fast. b. Repair the screw as required.
6. Reasons for failure to produce rods and material return: a. Insufficient temperature; b. Excessive screw pressure.
Wood Round Rod Making Machine
